Skateboarding requires a steady hand and precise balance. With a little know-how, you can learn to ride like a pro. Skateboarding requires bearings in order to provide the necessary friction to keep your wheels spinning while also providing adequate support. Without bearings, wheels will wobble and spin uncontrollably when turned at high speeds or on certain types of surfaces.
However, skateboard bearings can be difficult to remove from their sockets if they’re not removed properly. In this article, we’ll discuss how to take out bearings from skateboard wheels.
How to Take Bearings Out of Skateboard Wheels?
To take bearings out of skateboard wheels, follow the instructions below.
- Start by removing the axle nut with a skate tool or an Allen key.
- Once the axle nut is removed, you should be able to remove the wheel from the truck.
- To remove the bearings from the wheel, you will need to use a bearing extractor tool or a long nail.
- Insert the bearing extractor tool or nail into the bearing.
- Gently pull on the tool or nail until the bearing pops out of the wheel.
- Repeat steps four and five for the other bearings in the wheel.
- Once all of the bearings are removed, you can clean them with a rag and some skateboard bearing cleaner.
- To reinstall the bearings, simply insert them into the wheel and hand-tighten the axle nut. Be sure not to over-tighten the axle nut, as this can damage the bearings.
What Are the Different Methods to Remove Bearings From Skateboard Wheels?
There are a few different ways that you can remove bearings from skateboard wheels. The most common method is to use a bearing extractor tool or a long nail. However, you can also remove the bearings [1] by pressing on them with your fingers or another object.
How to Take Bearings Out of Skateboard Wheels by Hand?
Follow these instructions if you want to take bearings out of skateboard wheels using your hand.
- Begin by removing the axle nut using an Allen key or a skate tool.
- You should be able to remove the wheel from the vehicle once the axle nut has been removed.
- To remove the bearings from the wheel by hand, simply press on them with your fingers until they pop out of the wheel.
- Once all of the bearings are removed, you can clean them with a rag and some skateboard bearing cleaner.
- To reinstall the bearings, simply insert them into the wheel and hand-tighten the axle nut. Be sure not to over-tighten the axle nut, as this can damage the bearings.
Can You Take Bearings Out of the Wheels?
Yes, you can take bearings out of skateboard wheels. The process is fairly simple and only requires a few tools. However, it’s important to be careful when removing the bearings, as they can be damaged if not removed properly.
How Long Should Skateboard Bearings Last?
Skateboard bearings typically last between 6 and 12 months. However, this can vary depending on how often you skate and the quality of your bearings. If you take good care of your bearings, they will last longer.
What Are Some Tips for Taking Care of Skateboard Bearings?
There are a few things that you can do to extend the life of your skateboard bearings. First, be sure to clean them regularly with a rag and some skateboard bearing cleaner. Second, avoid riding in water or on wet surfaces, as this can rust the bearings. Finally, be sure to keep your bearings properly lubricated with oil or grease.
How Do I Know If My Skateboard Bearings Need to Be Replaced?
There are a few signs that your skateboard bearings need to be replaced. If your bearings are making noise, feeling gritty, or if the wheels are wobbling, then it’s time for new bearings. Also, if you can see rust on the bearings, they will need to be replaced.
Conclusion
Skateboard bearings are an important part of the skateboard and need to be taken care of properly. Be sure to clean and lubricate them regularly, and avoid riding in wet or dirty conditions. If you take good care of your bearings, they will last longer. Remember to replace them if they start to show signs of wear and tear.
